Aqua Ultraviolet – VIPER 400W Lamp Kit, 2" Plastic Unit
Overview
Factory lamp kit for the Aqua Ultraviolet VIPER 400W UV sterilizer with the 2" plastic housing. Restores peak germicidal performance for large, high-flow systems using a single high-output, low-pressure (amalgam) UV-C lamp.
Key Features
-
Genuine Aqua UV 400-watt HO UV-C lamp matched to 2" plastic VIPER units
-
OEM seals/hardware ensure correct fit, sealing, and stable UV dose
-
Service-friendly kit minimizes downtime on critical life-support loops
-
Ideal for aquaculture, big ponds, and commercial aquarium systems
Compatibility
-
For VIPER 400W sterilizers in the 2" plastic configuration
-
Not compatible with 2"/3" stainless or 3" plastic VIPER bodies, nor other wattages (800W/1200W)
Specifications
-
Lamp Power: 400 W (low-pressure amalgam UV-C)
-
Peak Wavelength: ~254 nm (germicidal)
-
Housing Fit: 2" plastic VIPER chamber
-
Service Life: Replace about every 9–12 months of continuous use (or per UV meter/dose targets)
What’s Included
-
(1) 400W UV-C lamp — VIPER, 2" plastic fit
-
(1) Set of end seals/O-rings sized for the 2" plastic end assembly
-
(1) Set of required end hardware/insulator(s) (kit dependent)
-
Quick install sheet
Installation & Safety Notes
-
Disconnect power and allow the unit to cool; isolate and depressurize plumbing.
-
Open end assembly; remove the old lamp and seals (avoid touching new lamp glass).
-
Inspect/clean the quartz sleeve; replace if cloudy, etched, or cracked.
-
Lightly lube new O-rings with silicone-safe grease; seat squarely.
-
Reassemble hand-tight, then snug—do not overtighten.
-
Restore flow, power ON, verify strike, and check for leaks after first run.
Want me to format this as a single-row Shopify CSV with your standard columns and tags?