Aqua Ultraviolet – SL 200 Watt Replacement Quartz Sleeve with Bushing & Rubber Seal
Overview
Factory replacement quartz sleeve for the Aqua Ultraviolet SL 200 UV sterilizer. The sleeve isolates the high-wattage lamp from water while maximizing UV-C transmission. Includes the correct end bushing and a new rubber seal for a clean, drip-tight rebuild.
Key Features
-
OEM high-clarity quartz sleeve matched to SL 200
-
End bushing included for proper alignment and support
-
Rubber seal (gasket) restores a reliable, leak-resistant cap interface
-
Quick swap when the old sleeve is stained, etched, or cracked
Compatibility
-
Fits Aqua Ultraviolet SL 200 UV sterilizers (two-lamp SL body family)
-
Not interchangeable with Classic-series sleeves or other SL wattages
Specifications
-
Part: Quartz sleeve with bushing & rubber seal — SL 200
-
Materials: UV-transparent fused quartz; engineered bushing; elastomer seal
-
Use: Inside sterilizer housing (component itself is not submersible)
What’s Included
-
(1) Quartz sleeve — SL 200
-
(1) End bushing
-
(1) Rubber seal / gasket
Replacement & Care Notes
-
Power OFF and let the unit cool; isolate plumbing and relieve pressure.
-
Remove end cap(s) and lamp(s); carefully withdraw the old sleeve.
-
Clean seating surfaces; lightly lubricate the new seal with silicone-safe lube.
-
Install sleeve and bushing squarely; reassemble hand-tight—do not overtighten.
-
Restore flow and leak-test. Replace UV lamps every 9–12 months and inspect the sleeve at each change.