Factory lamp kit for the Aqua Ultraviolet VIPER 400W UV sterilizer with 2" stainless steel housing. Restores peak germicidal performance for large, high-flow systems using a single high-output, low-pressure (amalgam) UV-C lamp.
Genuine Aqua UV 400-watt HO UV-C lamp matched to 2" stainless VIPER units
Maintains correct fit, sealing, and UV dose for reliable operation
Service-friendly kit minimizes downtime on critical life-support systems
Ideal for aquaculture, large ponds, commercial displays, and LSS loops
For VIPER 400W sterilizers in 2" stainless steel configuration
Not compatible with 3" plastic VIPER bodies or other wattages (800W/1200W)
Lamp Power: 400 W (low-pressure amalgam UV-C)
Peak Wavelength: ~254 nm (germicidal)
Housing Fit: 2" stainless VIPER chamber
Service Life: Replace about every 9–12 months of continuous use (or per UV meter/dose targets)
(1) 400W UV-C lamp — VIPER, 2" stainless fit
(1) Set of end seals/O-rings sized for stainless VIPER end assembly
(1) Set of required end hardware/insulator(s) (kit dependent)
Quick install sheet
Disconnect power and allow the unit to cool fully.
Isolate and depressurize plumbing; drain the chamber.
Open end assembly; remove old lamp and seals (avoid touching new lamp glass).
Inspect/clean the quartz sleeve; replace if etched, cloudy, or cracked.
Lightly lube new O-rings with silicone-safe grease; seat squarely.
Reassemble hand-tight, then snug—do not overtighten.
Restore flow, power ON, verify strike, and check for leaks after first run.