OEM raw transformer/ballast for Aqua Ultraviolet 80W UV sterilizers. Replaces a failed or aging power component to restore reliable lamp ignition and correct operating current.
Genuine replacement power component for 80-watt Aqua UV lamps
Provides proper start and run current for stable UV output
“Raw” (unhoused) part—ideal for service benches and in-house repairs
Compatible with wiper and non-wiper models
Aqua Ultraviolet Classic 80W UV sterilizers (all port sizes)
Not for other wattages (8W/15W/25W/40W/57W/114W/160W/etc.)
Type: Low-pressure UV-C lamp transformer/ballast (80W)
Input: 120V AC, 60Hz (typical)
Output: Matched to Aqua UV 80W low-pressure UV-C lamp
Form Factor: Raw component (no outer housing)
Leads: Pigtail wiring for line/neutral/ground and lamp connections
(1) 80W raw transformer/ballast
Disconnect power and isolate plumbing before service.
Mount in a dry, ventilated area—do not submerge or expose to spray.
Follow the factory wiring diagram; correctly terminate line/neutral/ground.
Use proper connectors/heat-shrink and strain-relief.
After installation, verify lamp strike and amperage; replace aged lamps/sleeve as needed.