OEM replacement wiper rod sized for Aqua Ultraviolet Classic & SL units in the 25W and 57W families. Restores smooth, effective sleeve wiping to help maintain consistent UV output.
Genuine Aqua Ultraviolet rod matched to 25W & 57W models
Rigid, corrosion-resistant construction for long service life
Smooth travel for even sleeve contact when paired with a good blade
Direct swap—no modifications required
Aqua Ultraviolet Classic and SL units rated 25W or 57W with manual wiper assemblies
Not for 8W/15W/40W/80W/114W/160W or other lengths
Part: Wiper Rod (length specific to 25/57W housings)
Materials: Durable shaft with factory end interface
Use: Internal wiper mechanism (non-submersible component)
(1) Wiper rod for 25/57W models
Note: This listing is rod only. Wiper blade, plastic clips, wiper nut, and seals/O-rings are sold separately.
Power off and depressurize the system before service.
Remove the end-cap; withdraw the old rod and blade.
Transfer or install a new blade/clip set onto the new rod.
Reassemble with a good wiper nut & seal; hand-snug only.
Cycle the wiper with the lamp off to confirm smooth travel, then leak-test.